Extrusion Cross-Bar

This is a 25 mm X 50 mm aluminum extrusion that mounts between the Warthog's Extrusion Rails. The Cross-Bar is installed with T-slot nuts and 90° brackets. The Cross-Bar can be attached anywhere along the length of the Warthog's Extrusion Rails.

Sales Kits

note

This kit requires a Warthog with Extrusion Rails. Refer to the Extrusion Rails page for further details.

Description	Sales Kit
Installation—Extrusion Cross-Bar, 25 X 50, 652	028455

Parts List

ID	Description	CPR item	Quantity
1	Beam, T-slot—25 X 50, 655, Aluminum, Black	028465	1
2	Bracket, T-Slot, 90°—5.8, 20, Aluminum, Black	028464	8
3	Nut, T-Slot—M5×0.8 X 5.8 X 10, Steel	028463	32
4	Screw, Cap, Socket Head—M5×0.8 X 10, Stainless Steel	023150	32

Tools required

• Hex Key, 4 mm
• Torque wrench (optional, for safety applications)
• Loctite 243 (optional, for high vibration applications)

Installation

Step 1

Attach 8 Brackets (ID2) to the ends of the Beam (ID1). Use 2 T-slot Nuts (ID3) and 2 Screws (ID4) per Bracket.

note

Torque these screws to 5 N·m if you are concerned about them loosening from high vibration applications.

note

You may add a small amount of thread locker to these screws if you are concerned about them loosening from high vibration applications.

Step 2

Add a T-slot Nut (ID3) and Screw (ID4) to each of the remaining holes of the Brackets (ID2). Leave these Screws loose, in anticipation of the next step.

note

You may add a small amount of thread locker to these screws if you are concerned about them loosening from high vibration applications.

Step 3

Slide the Cross-Bar assembly between the Warthog's Extrusion Rails. Make sure all 16 of the loose T-slot nuts are guided into the Extrusion Rails.

Step 4

Slide the Cross-Bar assembly to your intended final position on the Warthog per your application.

Step 5

Tighten all 16 Screws.

note

Torque these screws to 5 N·m if you are concerned about them loosening from high vibration applications.